ここから本文です
TWO:The two of us sprang forward. How long or what way we went I have now no clear idea, but at length we neared again the grapevine ferry. The stream was swollen, we swam our horses, and on the farther side we found Kendall waiting. To the corporal's inquiry he replied that Ferry had just passed on. "You know Roy's; two miles off the Plank Road by the first right? He expects to stop there."
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:No, he would not; only wagons went that way, to cross the creek by a small bridge. I could cut off nearly two miles by taking the bridle-path that turned sharply down into the thick woods of the creek-bottom about a quarter of a mile from the house and crossed the stream at a sandy ford. "Ride round," he said, "and I'll show you from the front of the house."

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:Once, when we were not halted or harkening, we heard overmuch; heard that which brought us to an instant stand and caused even Miss Harper to gaze on me with dismayed eyes and parted lips, and the blood to go thumping through my veins. From a few hundred yards off in the northwest, beyond the far corner of an old field and the woods at its back, two gunshots together, then a third, with sharp, hot cries of alarum and command, and then another and another shot, rang out and spread wanderingly across the tender landscape.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:The party remained three days at Canton. They rose early every morning, and went on excursions through and around the city, and it is fair to say that they did not have a single idle moment. Each of the boys made careful notes of what he saw and heard, and by the end of their stay both had enough to fill a small volume. They returned to Hong-kong on the fourth day, and on the morning after their return they sat down to write the story of their adventures. But before they began writing the projected letter a discussion arose between them, which was about like this:

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:No, I am not the least tired, he said. As soon as I have changed my clothes, I shall go down to my office.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.